Car Computer - Almost done TONS OF PICS NOW!
#11
Originally Posted by 94SLEeper
Are you gonna have a WiFi hotspot scanner in your car or something? I can't wait to see what your final pics look like of the set up!
OK here goes: Notes on the continuation of this project. The console will be painted or covered to match the dash, with a gray bezel finishing off the front of it. The radio is already flush-mounted. I am going to get rubber to fill in the gap between the ash-tray hole and my console. Its not too noticeable but it bugs me. The wood trim dash bezel was stock and has been modified to work temporarily, it will be replaced with a finished gray bezel.
Day time Pictures:
Installed from passenger side:
Screen running from driver side:
GPS Information Screen:
Guidance and routing software:
NIGHT SHOTS (warning all were taken with multi-second exposures so the numbers and sliders bars might look funky)
Vertical shot of screen and console:
Wide shot of whole dash from back seat. This was 13 seconds so the screen got kinda blown out light wise:
Interior lights on:
Flash!:
#14
Originally Posted by wjcollier07
hmm, i wonder how well that can be blended together. Probably quite well with some time and some fiberglass. Then texture and match with interior color and that thing will look AMAZING.
I am also planning on sinking the screen all the way into the dash, flush like. I had to pull it out because the opening in the wood grain stuff wasn't wide enough to hold it properly and i didn't want to hack it any further.
At the moment i have 1.5 of the three F'* needed in all designs.
I have the FUNCTION.
Half of the FIT.
Next is FORM.
As its my daily driver and i only had one weekend i had to settle on Fit and Function first.
Thread
Thread Starter
Forum
Replies
Last Post
bmsgaffer86
Your Ride: GM Pictures & Videos
17
05-08-2007 02:06 PM
Bassplayincrowe
Performance, Brainstorming & Tuning
13
07-05-2004 03:23 AM