Machine Shop???
#11
Senior Member
I don't care if it'* done with a CNC machine. It'll need finishing. Geez
The following users liked this post:
CathedralCub (02-03-2024)
#12
Member
Posts like a V-Tak
Thread Starter
They are professionals... so they will produce a quality part
So, there'* no need to worry about this at all, as things will work out swell
So, there'* no need to worry about this at all, as things will work out swell
The following users liked this post:
CathedralCub (02-03-2024)
#13
Senior Member
I'm sure of that. You would need to search hard to find a place that would screw up this job.
The following users liked this post:
CathedralCub (02-03-2024)
#14
Member
Posts like a V-Tak
Thread Starter
Well, the way the world is going... stuff happens!
When things get all screwed up is usually due to some pointy headed college boy being involved.
The leaders of our illustrious nation all have one thing in common... they are
went to an institution of "higher learning" where they lost their common sense.
When things get all screwed up is usually due to some pointy headed college boy being involved.
The leaders of our illustrious nation all have one thing in common... they are
went to an institution of "higher learning" where they lost their common sense.
The following users liked this post:
CathedralCub (02-03-2024)
#15
Senior Member
Well, the way the world is going... stuff happens!
When things get all screwed up is usually due to some pointy headed college boy being involved.
The leaders of our illustrious nation all have one thing in common... they are
went to an institution of "higher learning" where they lost their common sense.
When things get all screwed up is usually due to some pointy headed college boy being involved.
The leaders of our illustrious nation all have one thing in common... they are
went to an institution of "higher learning" where they lost their common sense.
The following users liked this post:
CathedralCub (02-03-2024)
#16
Senior Member
True Car Nut
I'm curious where you end up going and how it comes out!
#17
Member
Posts like a V-Tak
Thread Starter
It'* just for a Silverado that I did a 2/3 drop on that has the raked look... I just wanted to lift the front just slightly
It'* not anything major as this is a budget kinda deal.
That way the over all front drop will be 1 and 1/2 inches and the back is 3.25 inches
On the front I used 2 inch drop spindles and on the back I used 2 inch shackles and then removed the factory 1.25 inch spacer between the leaf springs and the axle.
By raising the front by a half inch, the trick won't look so raked and will be closer to looking more level.
It'* not anything major as this is a budget kinda deal.
That way the over all front drop will be 1 and 1/2 inches and the back is 3.25 inches
On the front I used 2 inch drop spindles and on the back I used 2 inch shackles and then removed the factory 1.25 inch spacer between the leaf springs and the axle.
By raising the front by a half inch, the trick won't look so raked and will be closer to looking more level.
The following 2 users liked this post by Rockrz:
carfixer007 (02-04-2024),
CathedralCub (02-05-2024)
Thread
Thread Starter
Forum
Replies
Last Post