Repositioning the main computer from horizontal position to
#1
Junior Member
Thread Starter
Join Date: May 2008
Location: Phoenix,AZ
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Repositioning the main computer from horizontal position to
I currently own a 2000Bonneville SSEI that we are removing the air box to make room for a 4pk HHO system. We added a K&n airfilter and need to take the computer and raise it verticle for room for the 4 generators in the engine compartment. Any suggestions on the building of a new housing to keep water off the computer and funnel air to keep it cool while driving?Also looking at maybe in the inside fender well area for placement of the generators on the frame as a possible avenue to explore.Any suggestions would be great,we need about 17 inches by 4 1/2 inches wide area or a area that is 8 inch by 9inches to p[lace the generators,Thanks for any input . Bob can email me at bobandannie@***.net
#3
The comptuer is completely fine in any position, and it is already weather sealed at the connections. No need to build a box.
You making something like tihs? http://www.youtube.com/watch?v=tbv_2B-c0WQ
Be sure to take lots of pictures!
You making something like tihs? http://www.youtube.com/watch?v=tbv_2B-c0WQ
Be sure to take lots of pictures!
#4
Senior Member
True Car Nut
Join Date: May 2005
Location: _Phoenix, AZ_ _WCBF '05, '06, '07 Survivor_ ____NEBF '07 Remnant___
Posts: 3,448
Likes: 0
Received 6 Likes
on
6 Posts
Welcome to BC from another Phoenician
Sounds like a very ambitious project
I know my '97 (as well as '98 and '99) has a stock vertical PCM holder and cover, but I don't think the 2000+ PCM will fit in the holder. '96 came with a holder with a lid that leaves most of the PCM open for airfolw I assuem, but again, I don't know if the 2000+ PCM fits in the holder. If you want to try to see if your PCM will fit in my '97'* PCM holder, it, I have no problem stopping by and letting you test fit it. Also, Intense-racing.com sells a PCM tray that allows you to relocate your PCM.
Sounds like a very ambitious project
I know my '97 (as well as '98 and '99) has a stock vertical PCM holder and cover, but I don't think the 2000+ PCM will fit in the holder. '96 came with a holder with a lid that leaves most of the PCM open for airfolw I assuem, but again, I don't know if the 2000+ PCM fits in the holder. If you want to try to see if your PCM will fit in my '97'* PCM holder, it, I have no problem stopping by and letting you test fit it. Also, Intense-racing.com sells a PCM tray that allows you to relocate your PCM.
Thread
Thread Starter
Forum
Replies
Last Post
tommytime
Everything Electrical & Electronic
1
01-30-2009 06:49 AM
loud95sse
Everything Electrical & Electronic
2
10-25-2007 01:58 PM