Nighthwk12's Intake Setup
#1
Senior Member
Posts like a Northstar
Thread Starter
Join Date: Feb 2009
Location: Northern Illinois
Posts: 789
Likes: 0
Received 0 Likes
on
0 Posts
Nighthwk12'* Intake Setup
Here it is, the outside of the throttle body isn't accurate (obviously) but its whats inside that counts:
Trajectory Study:
Particle Study:
I can get some high res stuff later if this isnt large enough, or if you want close ups of specific areas
Trajectory Study:
Particle Study:
I can get some high res stuff later if this isnt large enough, or if you want close ups of specific areas
#2
Senior Member
Posts like a Corvette
Join Date: Feb 2009
Location: Jersey Shore
Posts: 1,511
Likes: 0
Received 0 Likes
on
0 Posts
That is the coolest thing ever so my set up actually works I'm excited to put it on my car now. For the people just sitting down this is a gutted air box with a LQ4 Maf and L67 TB from a 2000 SSEi. You have a true talent trent.
#6
DINOSAURUS BOOSTUS
Expert Gearhead
Right, the maf still sticks in.. just doesn't have a full length post and the TB itself is smaller than say the 85mm diameter of the maf.
#9
Senior Member
Posts like a Corvette
Join Date: Feb 2009
Location: Jersey Shore
Posts: 1,511
Likes: 0
Received 0 Likes
on
0 Posts
Going to come up soon to hang out still getting all my parts together. I did just at my TB and see that Maf i guess you would call shelf. Going to port that. Grindy Grindy
#10
DINOSAURUS BOOSTUS
Expert Gearhead
Since you'll have an external maf, I'd either make a Dan style block off plate or cut the end off the maf and use the top as a plug. But you could sell it.