Modified trans pan
#21
DINOSAURUS BOOSTUS
Expert Gearhead
Orrrr we could find another guy and 95 Slab. If I ship you three, you make all of them up. Swap one onto your car and make that one as well. Then the other two guys toss each of us a little cash to cover the pans and work/material.
That way you and I get freebies and they get low cost. It'* been a thought of mine for a while. I just haven't gotten over to my local TIG buddies place yet.
That way you and I get freebies and they get low cost. It'* been a thought of mine for a while. I just haven't gotten over to my local TIG buddies place yet.
#22
Senior Member
Posts like a Corvette
Join Date: Feb 2009
Location: Jersey Shore
Posts: 1,511
Likes: 0
Received 0 Likes
on
0 Posts
#23
DINOSAURUS BOOSTUS
Expert Gearhead
Dan said this when I asked him.
I cut a steel bar then milled it flat and so the end of the plug wont stick out. Then welded it in place, and then drilled the hole in the pan.
Thread
Thread Starter
Forum
Replies
Last Post
salmanman
Performance, Brainstorming & Tuning
2
04-07-2003 11:37 AM
2000SilverBullet
Performance, Brainstorming & Tuning
5
02-11-2003 12:48 AM