Getting started on my spring project.
#81
Okie Hokie
Posts like a Camaro
Join Date: Dec 2008
Location: Durant, Ok 74701
Posts: 1,107
Likes: 0
Received 0 Likes
on
0 Posts
I agree with john in thats "thats some manly porting"... ill be suprised if the sc doesnt fall into the hole lol j/k
paints lookin good... really inspiring me to tear mine down and port/polish it all up and paint it this summer...
good job dano
paints lookin good... really inspiring me to tear mine down and port/polish it all up and paint it this summer...
good job dano
#82
Retired Senior Admin
Expert Gearhead
Thread Starter
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 29 Likes
on
25 Posts
Got a little more work done today.
First I marked 5/8" so I knew how deep to cut.
Bolted down the cutting head.
Put some tension on the cutting bit.
And started turning
After about 20 minutes.
All done. Now I can run some really small pulleys.
First I marked 5/8" so I knew how deep to cut.
Bolted down the cutting head.
Put some tension on the cutting bit.
And started turning
After about 20 minutes.
All done. Now I can run some really small pulleys.
#86
Okie Hokie
Posts like a Camaro
Join Date: Dec 2008
Location: Durant, Ok 74701
Posts: 1,107
Likes: 0
Received 0 Likes
on
0 Posts
<--- Interpretted as meaning... "Now I can see how fast i can blow the heads off the block with boost, I always wanted a ram air hood... maybe at 50lbs the heads will go THROUGH the hood and save me the trouble of cutting slots" lol j/k dan thats awesome using the cutting tool for that... we have 2 machine ones and 1 hand crank at the shop but theyre usually used for turning down rotors
#87
Retired Senior Admin
Expert Gearhead
Thread Starter
Join Date: May 2006
Location: Sheboygan Wisconsin
Posts: 29,661
Likes: 0
Received 29 Likes
on
25 Posts
Got a bit more done. Figured I would post while my toes thaw out.
Still need to finish this. But I want to get on the Milling machine to remove the H bar and then cut away the bolt bosses.
Got the intake clean up a little, but still need to work on this.
Then I threw it all together for a photo shoot. The snout got a little messed up when I cut it down, so that needs to be cleaned up.
Still need to finish this. But I want to get on the Milling machine to remove the H bar and then cut away the bolt bosses.
Got the intake clean up a little, but still need to work on this.
Then I threw it all together for a photo shoot. The snout got a little messed up when I cut it down, so that needs to be cleaned up.
#88
Senior Member
True Car Nut
That is looking mighty nice. I appreciate the updates, it helps with my learning curve about SC and performance enhancements for the Bonny.
One question...which area is the "H" bar?
One question...which area is the "H" bar?