Did you know?
#43
Senior Member
True Car Nut
Join Date: Dec 2002
Location: Sauk Centre, MN
Posts: 5,459
Likes: 0
Received 0 Likes
on
0 Posts
ZZP sells Series I rockers and I spent some time on the phone with them (Tim and Zoomer) today discussing Series I products, as well as business from BC land.
I didn't mention anyone'* names, SN'*, other than BC, but ya never know.
I didn't mention anyone'* names, SN'*, other than BC, but ya never know.
#44
Senior Member
Posts like a Northstar
Join Date: Jun 2005
Location: Yulee , FL ___ SEBF Survivor
Posts: 700
Likes: 0
Received 0 Likes
on
0 Posts
My friend and I finished rebuilding a 4.3 this week in my garage. The pushrods we had were out of a roller motor, and thus were shorter, so I ordered some through my work (Marine Dealer), I got some for use in a marine 4.3, they were so much beefier than stock. They were made in South Africa, go figure.
#45
Junior Member
Posts like a Ricer Type-R
Thread Starter
Originally Posted by wjcollier07
Just curious, but can't you just attain these pushrods from some place like Advance, Checker, AutoZone? I was under that impression.
So we're at 5/16, 8", what'* the diameter of the oil hole? Anyone have any L27 or L67 pusrods out of a Series 1 for comparison/measurement?
#46
Senior Member
True Car Nut
Join Date: Aug 2004
Location: In your garage, swipin' da lug nutz
Posts: 3,067
Likes: 0
Received 1 Like
on
1 Post
Originally Posted by willwren
So we're at 5/16, 8", what'* the diameter of the oil hole? Anyone have any L27 or L67 pusrods out of a Series 1 for comparison/measurement?