1993 SSEi supercharger
#1
1993 SSEi supercharger
I have found all the parts to repair the supercharger nosecone except for the disc that attaches the shaft to the gear of the propeller. I'm not sure what it is called, but it is a composite material ( it looks like) and it has six holes in it. Can anyone help me out with a part number?
#3
It sounds like you are looking for this:
Which is available here:
http://www.zzperformance.com/zzp/pro...sc_coupler.htm
If it is what you are looking for I would get it from ZZP. They are a direct replacement for the stock one. A few of use already use them (including me) and have had no trouble with them yet. This is the only place I know of that you can buy one. I believe the dealer wants you to buy the whole SC or nose cone to get it. :?
Which is available here:
http://www.zzperformance.com/zzp/pro...sc_coupler.htm
If it is what you are looking for I would get it from ZZP. They are a direct replacement for the stock one. A few of use already use them (including me) and have had no trouble with them yet. This is the only place I know of that you can buy one. I believe the dealer wants you to buy the whole SC or nose cone to get it. :?
#4
I was just going to say this! You beat me to it.
http://www.bonnevilleclub.com/forum/...pic.php?t=2302
http://www.bonnevilleclub.com/forum/...pic.php?t=2302
#6
Senior Member
Posts like a Northstar
I hope you're planning on replacing the oil seal in the nose too. The OEM seal is made of Teflon and has no part number markings on it, and I know this because I've had to replace them on both of my bonnies in the last year or so because they were leaking - the seal had torn or separated internally and was rotating when the shaft rotated! From what I've read, most people use the Chicago Rawhide #CR7965 (nitrile rubber), but I used the better #CR7968 (Viton) instead.
Thread
Thread Starter
Forum
Replies
Last Post
krists
Forced Induction
4
07-01-2005 09:39 AM