taking apart the driver information center to replace bulb
#1
Senior Member
Posts like a Corvette
Thread Starter
taking apart the driver information center to replace bulb
how do i take this thing apart i know i take out the screw and all that but what about the ones that look glued down? what do i do about those, what kind of glue do i use to glue them back down, and is there anything else is should know about this? aslo what kind of bulbs do i use as replacements
#3
Senior Member
Posts like a Corvette
Thread Starter
my service engine soon light wont work. what could the problem be, and could i switch these lights out of maybe the volt warning or anything like that to fix it
#4
OK, follow this procedure in Techinfo - There should be no glue involved, however, you must be very careful when taking it apart.
http://www.bonnevilleclub.com/techinfo/?article=56
http://www.bonnevilleclub.com/techinfo/?article=56
#6
Junior Member
Posts like a Ricer Type-R
The dealer for sure, maybe autozone. That'* the procedure I was telling you about yesterday. Just be careful when taking it apart. Remember where everything went.
#7
Senior Member
True Car Nut
Join Date: Dec 2002
Location: Halifax, Canada 91SSE / 97SSEi
Posts: 5,857
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by fuddyduddy121
OK, follow this procedure in Techinfo - There should be no glue involved, however, you must be very careful when taking it apart.
http://www.bonnevilleclub.com/techinfo/?article=56
http://www.bonnevilleclub.com/techinfo/?article=56