key programming
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Dec 2005
Location: Ebensburg, PA
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
key programming
i just had to buy a new key because i lost my last set, however i dont know how to program it to work with my car. does anyone know how to make my new key work? im getting pretty frustrated not being able to drive it now for over a month! thanks!
#2
Where'd you get the key from? If you don't have the old one to measure the resistance of the pellet, then you'll have to get a new one from the dealer, based on your VIN.
#4
Senior Member
Certified Car Nut
Originally Posted by vital49
Where'd you get the key from? If you don't have the old one to measure the resistance of the pellet, then you'll have to get a new one from the dealer, based on your VIN.
im gonna assume that you need the TECH2 to program it
#5
Senior Member
Certified GM nut
Go get your manual if you have DIC which you do being an SSEi owner read about it in there. Yes there is a way of should be unless they need a Tech 2 like 93 SLE said. Try it my way first tho. Good luck!
#6
Member
Posts like a V-Tak
Thread Starter
Join Date: Dec 2005
Location: Ebensburg, PA
Posts: 45
Likes: 0
Received 0 Likes
on
0 Posts
Thanks guys! I finally figured it out though!
3 step process
Half hour with a good battery or connected to a charger
start with new key.. it wont start but leave in on position
ten minutes later turn key again and leave in on position
third time, repeat process
ten minutes later it should start right up... it did for me!
3 step process
Half hour with a good battery or connected to a charger
start with new key.. it wont start but leave in on position
ten minutes later turn key again and leave in on position
third time, repeat process
ten minutes later it should start right up... it did for me!
Thread
Thread Starter
Forum
Replies
Last Post