DRL Jumper Question
#1
Thread Starter
Senior Member
Posts like a Turbo
Joined: Nov 2005
Posts: 406
Likes: 0
From: Columbia, MO "CoMo"
DRL Jumper Question
I know the process regarding 30/87a to disable the DRL'*, but was curious as to the construction of the jumper itself. What did you use for the ends? Spade connectors? All of the spade connectors I found looked too wide. Not sure if I'm going to disable them yet but am tossing it around.
Thanks.
Thanks.
#2
I used spade connectors attached to an insulated 12ga wire but took a pair of side cutters and cut off one of the two prongs from each end. Fits like a glove into the slot and VERY secure. Also makes it a snap to remove the jumper and plug the relay back in if you need to do so.
#3
Originally Posted by ozarkirish87
I used spade connectors attached to an insulated 12ga wire but took a pair of side cutters and cut off one of the two prongs from each end. Fits like a glove into the slot and VERY secure. Also makes it a snap to remove the jumper and plug the relay back in if you need to do so.
Thread
Thread Starter
Forum
Replies
Last Post