trim around windshield.
#1
Senior Member
Posts like a Turbo
Thread Starter
Join Date: Mar 2003
Posts: 419
Likes: 0
Received 0 Likes
on
0 Posts
trim around windshield.
does anyone knowhow hard is it to replace and what are the part numbers..
i am getting air sounds in mine but no water????
thanks
i am getting air sounds in mine but no water????
thanks
#2
Junior Member
Posts like a Ricer Type-R
Wind noise from the top is typically your moonroof seal, or a misaligned moonroof. I'd suggest using some painters tape (at least 1".....the blue or green low-tack stuff) all around your moonroof seal on the roof to isolate the noise.
If that isn't it, I can look up the windshield trim procedure for you. I don't have time to dig right now.......
If that isn't it, I can look up the windshield trim procedure for you. I don't have time to dig right now.......
#3
Senior Member
Posts like a Turbo
Thread Starter
Join Date: Mar 2003
Posts: 419
Likes: 0
Received 0 Likes
on
0 Posts
thanks willwren but i am pretty sure it is the windshield trim as i can tell it is popped up..but only since i had my car painted..would they have needed to take the trim off for some reason... :?: they said they didn't but it is popped up all around.
#4
Junior Member
Posts like a Ricer Type-R
Maybe not, but they WOULD have had to remove your moonroof to paint around it. Unless you see evidence (paint line) that shows they didn't. Now I suspect a misalignment in the moonroof or a seal even more.
Does the moonroof open/close freely, and does it sit perfectly flush when it'* closed?
Does the moonroof open/close freely, and does it sit perfectly flush when it'* closed?
#5
Senior Member
Posts like a Turbo
Thread Starter
Join Date: Mar 2003
Posts: 419
Likes: 0
Received 0 Likes
on
0 Posts
they didn't remove it they taped it off i can tell plus i saw it when it was taped off..it opens/closes as normal no difference but i can check the noise by putting tape on there..
Thread
Thread Starter
Forum
Replies
Last Post