Tranny "relearns" after disconnection of PCM??
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Dec 2008
Posts: 79
Likes: 0
Received 0 Likes
on
0 Posts
Tranny "relearns" after disconnection of PCM??
Just wondered if the transmission will "relearn" your driving /shifting style after the battery or PCM is disconnected?? Just wanted the tranny to start with a clean slate after clearing previous stored faults/codes that have been addressed...........
#3
Member
Posts like a V-Tak
Thread Starter
Join Date: Dec 2008
Posts: 79
Likes: 0
Received 0 Likes
on
0 Posts
As a side note..............I've been chasing a "searching" condition I've been having with the tranny not knowing what gear to change into under load conditions like going up a small hill when in OD..........she "searches" for the right gear before settling into kicking down into 2 and then moves normally..................I found that a short piece of vacuum hose that connects a hard line to the modulator? on the side of the tranny was almost broken in half so I replaced the 2" piece and it "seems" to have cured the problem (fingers crossed) but time will tell.............might wanna check those vac lines as a preventative measure....
Thread
Thread Starter
Forum
Replies
Last Post
PRD2BDF
Your Ride: GM Pictures & Videos
36
11-22-2006 09:00 PM
PRD2BDF
Performance, Brainstorming & Tuning
24
06-12-2006 10:44 AM