Resetting wiper motor on a 93 SSE
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: Feb 2009
Posts: 55
Likes: 0
Received 0 Likes
on
0 Posts
Resetting wiper motor on a 93 SSE
Well during our deep freeze a couple weeks ago,my wipers were frozen in ice and could only move a inch or two so I just never used them till it thawed enough to chip it out / melt.
So now I start the car up today and turn the wipers on ( delay mode ) and nothing....turn the switch to low / always on...nothing...turn on high and they kick in but still only move a inch or two,there is no ice or anything blocking the arms....
Is there a way to reset the motor or is it fubar and time for a replacement ?
Thanks appreciate the help / info .
So now I start the car up today and turn the wipers on ( delay mode ) and nothing....turn the switch to low / always on...nothing...turn on high and they kick in but still only move a inch or two,there is no ice or anything blocking the arms....
Is there a way to reset the motor or is it fubar and time for a replacement ?
Thanks appreciate the help / info .
#5
Member
Posts like a V-Tak
Thread Starter
Join Date: Feb 2009
Posts: 55
Likes: 0
Received 0 Likes
on
0 Posts
well I am not physically able to actually get the cover off to look so I will have to find someone to check it out I guess...
Anybody here from st.paul that can check it out,I can give some $$ for your time.
Anybody here from st.paul that can check it out,I can give some $$ for your time.
#6
Member
Posts like a V-Tak
Thread Starter
Join Date: Feb 2009
Posts: 55
Likes: 0
Received 0 Likes
on
0 Posts
Well still looking for some help,tried to tackle it myself but cannot get under the hood far enough,I got one big cover off the pass side but it is a cover for fuses and gave no access to the wiper gear arms...
I can come to you...as long as it is not snowing or raining .....
Thanks..
I can come to you...as long as it is not snowing or raining .....
Thanks..
#8
Member
Posts like a V-Tak
Thread Starter
Join Date: Feb 2009
Posts: 55
Likes: 0
Received 0 Likes
on
0 Posts
Sure did and parking is not my issue which is they only move 2 inches total in a cycle ,most problems here are they are not parking in the correct position.
I suspect it is a bent wiper motor arm as this happened after they were froze in ice and did not know this when I turned them on...
I suspect it is a bent wiper motor arm as this happened after they were froze in ice and did not know this when I turned them on...
Thread
Thread Starter
Forum
Replies
Last Post