Removal of plastic piece without breakage
#1
Senior Member
Certified Car Nut
Thread Starter
Removal of plastic piece without breakage
How the heck do I get the plastic pieces off the wire harnesses over the SC nosedrive? I tried a few times and quit so I didn't beak it. Is there a trick to it? :?
#3
Senior Member
Certified Car Nut
Thread Starter
Originally Posted by Bonneville94V688
Carefully pull up on the front of it. It will pop off.
#5
Senior Member
Certified Car Nut
Thread Starter
Originally Posted by Bonneville94V688
Yes. Pull up on it and it will pop off.
#6
Senior Member
True Car Nut
Join Date: Dec 2002
Location: Sauk Centre, MN
Posts: 5,459
Likes: 0
Received 0 Likes
on
0 Posts
Pete, he'* right. If you lift up on the front it'll pop right up (Should anyhow) and then you pull the lid forwardand the top will come right off the bottom.
#7
Senior Member
Certified Car Nut
Thread Starter
Cool. It'* probably one of those things that looks harder than it is. For as hard as it was for me to figure out, it seemed to easy by the directions. But I'll give it another shot. Thanks guys.
#9
Senior Member
Certified GM nut
Join Date: Sep 2005
Location: Home Sweet Home in New York
Posts: 2,009
Likes: 0
Received 0 Likes
on
0 Posts
Pete, when I removed it, I held the wires and pulled from the bottom edge until it poped. I then did the reverse on the top. Basically I tried to immobilize the wiring.
Thread
Thread Starter
Forum
Replies
Last Post
350TPI
Detailing & Appearance
1
06-26-2007 09:19 PM