Problems Problems.....
#1
Junior Member
Thread Starter
Join Date: Nov 2005
Location: nc
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Problems Problems.....
New to the forum and have a few problems, Bought a 1994 sse with the stove pipe in the transmission busted (no 2nd no reverse) car had sat for 7 months, fixed the tranny and drove it home, stalled a few times and then would not start, checked ignition it was ok, changed the cranks sensor, same thing, plugged the noid light up no fire, changed the ecm starts every time, now transmission changes through the gears too fast, and even when i manually change the gears the car seems lazy, also when in park if I rev it to about 3k rpms and let off it dies every time and will fire right back up, I changed the IAC and this did not help, I have a genisys scanner but it will not read this car, it has a obd2 connector but a obd1 computer????
Car is super nice i just want it to run nice
Thanks for any help
Car is super nice i just want it to run nice
Thanks for any help
#2
Senior Member
Posts like a Supercharger
Join Date: Aug 2002
Location: Holley, NY
Posts: 190
Likes: 0
Received 0 Likes
on
0 Posts
stalling
Check the fuel pressure at the fuel rail. Should be 40+ at idle 47 at running. Could be a bad fuel pump.
Tranny...... Take it tool the tranny shop for advice.
Tranny...... Take it tool the tranny shop for advice.
#4
Junior Member
Thread Starter
Join Date: Nov 2005
Location: nc
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Ok checked the fuel pressure at idle 35psi, uplug the regulator 44psi, even when the regulator is unhooked its still lazy and shifts into 2nd gear at about 3mph, when it gets into over drive it will not kick down when i open it wide open. Still no check engine light. :(
#5
Member
Posts like a V-Tak
Did you check you TV cable. I would definately check your TV cable. It sounds like there is something internally wrong with your transmission. I would have a transmission shop take a look at it.
#7
DINOSAURUS BOOSTUS
Expert Gearhead
You mention changing ECM, did you put your prom into the new computer or did you keep the old one?
The chip needs to be changed for trans settings etc unless the car the ECM came from was identical including trans ratio etc that your car did.
The chip needs to be changed for trans settings etc unless the car the ECM came from was identical including trans ratio etc that your car did.
#9
Junior Member
Thread Starter
Join Date: Nov 2005
Location: nc
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Checked the tps voltage 5 volts on the hot side .54 volts at idle on the output side but it does not increase with throttle. So hopefully a new tps will solve all my problems