ABS Module
#1
Thread Starter
Senior Member
Posts like a 4 Banger
Joined: Jul 2007
Posts: 137
Likes: 0
From: Rochester, NY 14609
ABS Module
i recently have been notified that i need to change my brake lines because with the upcoming winter and salt that is on its way little bit of rust that is on them will the whole thing into dust. so before i do replace them anybody no where i could get that ABS piece from?
#3
Thread Starter
Senior Member
Posts like a 4 Banger
Joined: Jul 2007
Posts: 137
Likes: 0
From: Rochester, NY 14609
ok on my brake line in between my driver door and my driver passenger door there is a connector like piece on it that i believe to be the ABS piece for the brakes
#5
The only thing that I can think of near that area is the brake proportioning valve, but as I recall, those are near the rear wheel. A cylindrical device, maybe roughly the size of a "AA" battery. Other than that, I too am lost as to what it may be, and agree a picture would help a lot.
#7
Thread Starter
Senior Member
Posts like a 4 Banger
Joined: Jul 2007
Posts: 137
Likes: 0
From: Rochester, NY 14609
ok right now, im not to sure about exactly if this is the part. but i've been trying to find a picture of a antilock brake control module on the net to see if it matches the part that i have. but i have a good feelin that it what it is because it was on both the left and right brake cables
#8
Those aren't part of the ABS system. They're part of the traditional brake system.
The only components in the ABS system are:
1. Wheel speed sensors built in to each of the 4 hub/bearing assemblies.
2. EBCM Electronic Brake Control Module. Mounted to the right of the gas pedal under the carpet up through 1993. Under the hood near the master cylinder from 94 on.
3. PMV. Pressure Modulator Valve. The big doo-hicky under your stock airbox with the brake lines, round motor housing, and reservior.
That is simply the entire ABS system. There are no other components.
The only components in the ABS system are:
1. Wheel speed sensors built in to each of the 4 hub/bearing assemblies.
2. EBCM Electronic Brake Control Module. Mounted to the right of the gas pedal under the carpet up through 1993. Under the hood near the master cylinder from 94 on.
3. PMV. Pressure Modulator Valve. The big doo-hicky under your stock airbox with the brake lines, round motor housing, and reservior.
That is simply the entire ABS system. There are no other components.