93 a/c pump on a 96SC engine. wiring trouble
#1
Member
Posts like a V-Tak
Thread Starter
Join Date: May 2009
Location: Newfoundland, Canada
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
![~Baker~ is on a distinguished road](https://www.gmforum.com/images/reputation/reputation_pos.gif)
![Default](https://www.gmforum.com/images/icons/icon1.gif)
I recentley swaped my series one engine in my 93 out for a series 2 supercharged engine out of a 96. I changed then entire wireing in the car interior, tail lights, tranny, side axles, abs pump, rack and pinion, pretty much everything but the ac pump. I took the bracket off the 93 engine and cut off the unneeded peaces and it bolted right up to the series 2 supercharged engine. I had to extend the top bolt hole out a bit with a bracket to clear the supercharger belt. now that it is all put in I have ran into a little trouble.
The clutch wiring on the two pumps is the same but the senors in the lines are different.
the 93 system has a sensor up in that round rig and one down by the pump in a line "2 wires going to each" wile in the wireing harnes of the 96 witch i have installed there is only one sensor wire down by the part that bolts to the pump with 3 wires comming out of it..
did that one sensor in the 96 ac system do the job of the 2 in the 93 ac system can i just wire both 93 sensors into that one plug on the 96 wiring?, also what are they for so I can wire them corectley. are they just presure switches?
And if anyone has the wireing for the 93 and 96 ac systems can you send it to me?
Thanks!!!!!
The clutch wiring on the two pumps is the same but the senors in the lines are different.
the 93 system has a sensor up in that round rig and one down by the pump in a line "2 wires going to each" wile in the wireing harnes of the 96 witch i have installed there is only one sensor wire down by the part that bolts to the pump with 3 wires comming out of it..
did that one sensor in the 96 ac system do the job of the 2 in the 93 ac system can i just wire both 93 sensors into that one plug on the 96 wiring?, also what are they for so I can wire them corectley. are they just presure switches?
And if anyone has the wireing for the 93 and 96 ac systems can you send it to me?
Thanks!!!!!
Thread
Thread Starter
Forum
Replies
Last Post
Mike Sessei
Audio (and aftermarket electronics)
7
10-20-2007 01:01 PM
OLBlueEyesBonne
Everything Electrical & Electronic
2
02-22-2007 05:52 PM