4T60-HD-E, 1st and reverse only.
#1
Retired
Thread Starter
4T60-HD-E, 1st and reverse only.
On the way home tonight, trans did something, I don't know, but I now only have 1st and reverse. Luckily a friend from work was right behind me and was able to give me a lift home.
I wonder if I disconnect the trans connector, if I can force it into limp mode and that should at least give me 3rd gear.
Just looking for everyone'* thoughts if anyone is familiar with this trans.
I wonder if I disconnect the trans connector, if I can force it into limp mode and that should at least give me 3rd gear.
Just looking for everyone'* thoughts if anyone is familiar with this trans.
__________________
Retired Administrator
Retired Administrator
#2
Member
Posts like a V-Tak
Mike - no firsthand experience, but did find the attached link, which contains the following statement for 4T60-E, page 1360: 'Both solenoids are off in 3rd gear, so this would be limp-in mode for this transmission".
Automotive Service: Inspection, Maintenance, Repair - Tim Gilles - Google Books
That help at all?
Mealticket
Automotive Service: Inspection, Maintenance, Repair - Tim Gilles - Google Books
That help at all?
Mealticket
#3
Senior Member
I used to have a used trans harness that I cut the end off of to ohm check the solenoids. With my tech 2 I can also comand the transmission into any gear. I'm hoping for your sake it'* electrical and not mechanical.
#4
Retired
Thread Starter
Thanks Don, yea, I pretty much found the same info in my ATSG manual about the limp mode thing.
Well either way William, if its electrical or mechanical, that trans is still coming out.
Well either way William, if its electrical or mechanical, that trans is still coming out.
__________________
Retired Administrator
Retired Administrator
#5
Senior Member
Sorry to hear about that Mike. Only having first gear truly sucks.
Sounds like a good opportunity to get the camera working along the way, and create a 4T60-HD-E rebuild post...
Sounds like a good opportunity to get the camera working along the way, and create a 4T60-HD-E rebuild post...
__________________
1997 Buick Pk Ave (Soft Ride) Suspension!
1997 Buick Pk Ave (Soft Ride) Suspension!
#6
Senior Member
If it winds up being something like a stuck shift solanoid you should be able to lower the drivers side of the cradle enough to remove the side cover so you don't need to remove the whole thing.
#8
Senior Member
True Car Nut
Sorry to hear about the transmission problems, I know very little about transmissions so i cannot offer any help, but I do hope it is something that is an easy fix for you!
#9
Artist
True Car Nut
On my 4t65e the valve body went out and it failed to go into gear. Could be a partial failure of something similar. Has the transmission been a little slow to shift here and there? Mine would shift out of gear when up shifting, rev in neutral for a second then decide it actually wanted to go into the higher gear. This happened for months before it completely failed (Note it didn't happen EVERY upshift, it was a random occurrence)