1998 serpintine belt
#2
Pull the wheel and splash shield. Then looking at the bottom of the mount, pull the bottom bolt and the spacer behind that. This allows you to slide belts in and out. w/o taking the mount off completely.
#3
Joined: May 2006
Posts: 29,661
Likes: 34
From: Sheboygan Wisconsin
Wait, non supercharged, that don't go threw the motor mount, does it? If so, then ya, the lower front bolt is a stud, remove that nut, then the stud and knock out the spacer. Be careful, the crank sensor is right there.
Thread
Thread Starter
Forum
Replies
Last Post